request quote

How to remove wall paper

December 13, 2010 at 10:16 am | Category: Remodeling Contractor



Step 1: Prepare the Room
Place drop cloths at the base of the walls to be stripped. Remove all switch plates and outlet covers from the walls. Cut the power to the room.
Step 2: Score Wallpaper
Use a wallpaper scorer to create small holes in the paper, which allows the solution to penetrate through to the adhesive base.
Step 3: Mix Solution
While there are a number of commercially prepared solutions available, little works better than hot water and fabric softener. Combine the water and fabric softener in a large spray bottle at a concentration of one to one.

Tip: Mix the solution in small batches to keep the water as hot as possible.
Step 4: Soak Walls
Use a spray bottle to saturate a section of the wallpaper. Spray only as much of the wall as you can comfortably strip in a 15-minute period. Allow the solution to soak the paper for a few minutes before beginning.
Step 5: Strip WallpaperGrab pieces of wallpaper at a bottom corner and carefully pull upward. Use a wide putty knife to facilitate the removal of the paper. Repeat the above steps until all the wallpaper is removed.
Step 6: Clean Walls
In a bucket mix a tablespoon of dish detergent with very hot water. Use a sponge to wipe down the walls, scrubbing carefully to remove all traces of wallpaper adhesive. Finally, rinse down the walls with clean water and towel dry.


If you are looking for a Denver remodeling contractor then please call 303-833-4715 or complete our online request form.