request quote

Laying Glass Tile

December 8, 2010 at 12:07 pm | Category: Remodeling Contractor



Materials Needed:
opaque glass tile
non-sanded grout
thinset adhesive
V-notched trowel
level
sandpaper
glass tile cutter
tile spacers (optional)
wax pencil
bucket
sponge
rubber grout float
Eliminate Power
Turn off power to all walls where you’ll be working and remove outlet covers on the area to be tiled.
Prep the Wall
Using 80- or 90-grit sandpaper, thoroughly sand the backsplash area to be tiled. Wipe walls with a damp rag to remove any loose debris. Find the visual center of the wall. This is where you will begin tiling. Use a level to draw a centerline through the visual center.
Dry Fit Tiles
Make sure you understand how your tile will lay out, and that you will be happy with the fit by doing a dry layout on the floor before adhering tile to wall
Apply Thinset Adhesive
Apply thinset to a small area of the wall at the centerline. Start at the bottom of the wall, holding your trowel at an angle so the V-grooves cut into the thinset giving it a grooved texture which will help to grip the tiles. Wipe thinset onto the wall in sweeping motion, being careful to only apply enough adhesive that can be covered by a few tiles at a time.
Add Glass Tiles
Place tiles over thinset, pressing them evenly into the adhesive. Use the centerline as visual reference to keep your tile application level as you continue to apply tiles. Work in a small area at a time, adding adhesive and tile until you reach the top of the area to be tiled. If the thinset begins to set before you apply tiles, just scrape it off and re-apply. Optional: To assist in placing the tiles evenly with consistent grout lines, use tile spacers to separate them.
Cut Remaining Tiles to Fit
Mark the last row of tile with a wax pencil to the appropriate size and cut the tile with a glass tile cutter.
Apply Grout
Wait 24 hours for adhesive to cure before applying grout. Mix grout in a bucket according to the manufacturer’s directions. Apply grout along tile seams so it fills them in completely. Do not grout the bottom seam, this will be filled with caulk in a later step.
Clean Surface of Tile
Using a soft, wet sponge, remove excess grout from the tile’s surface. Use a gentle approach so you don’t wipe grout out of the seams. After an hour, buff glass tiles to remove the hazy film left by grout and water.
Clean Surface of Tile
Using a soft, wet sponge, remove excess grout from the tile’s surface. Use a gentle approach so you don’t wipe grout out of the seams. After an hour, buff glass tiles to remove the hazy film left by grout and water.


If you are looking for a Denver remodeling contractor then please call 303-833-4715 or complete our online request form.